Oki OKIPOS408II OKIPOS 408II Programmer s Technical Reference - Page 269

ESC B n d1d2 LF NUL [Name] [Code] Cutter control ASCII Hex. Decimal ESC B 1B 42 27 66 n d1 d2 LF n d1 d2 0A n d1 d2 10 NUL 00 0 [Defined Area] [Initial Value] n = 42, 43, 44, 47, 64 ( n 48 ≤ d1 ≤ 57 ("0" ≤ d1 ≤ "9"), 48 ≤ d2 ≤ 57 ("0" ≤ d2 ≤ "9") "00" ≤ d1 d2 ≤ "50" - - - [Function] Parameter details • n: Direction of offset "+": Offsets in the plus direction according to a standard feed value and performs a full cut. "-": Offsets in the minus direction according to a standard feed value and performs a full cut. "*": Offsets in the plus direction according to a standard feed value and performs a partial cut. "/": Offsets in the minus direction according to a standard feed value and performs a partial cut. "@": Cutter drive invalidated except for next issue. (Use this when cutting several sheets of paper. In that case, do not specify d1 d2. ) • d1 d2: Offset amount Unit 0.1 mm Note: The parameters (n d1 d2) can be omitted together. When doing so, a full cut on a standard paper feed is set. Drive of the auto cutter is enabled. When a presenter is equipped, a full cut is used for the paper cut. For cutters that leave on uncut portion, it does not return paper after the cut. The cutter is driven after paper is issued only by setting this command. This command is valid when performing a TOF using the black mark function. Settings using this command are cleared by the format initialization command (ESC C). See APPENDIX 6 for operations of this command on the label printer TSP828L. _____ STAR Page Mode Command Specifications 3-28