Panasonic AJHPX2700G AJHPX2700G User Guide - Page 133

Manipulating Clips with Thumbnails Selecting the USER CLIP NAME recording method Select META DATA  USER CLIP NAME from the thumbnail menu to select the recording method. Two options are available: TYPE1 and TYPE2. TYPE1 (Factory setting) USER CLIP NAME to be recorded If clip metadata has been read in Uploaded data If no clip metadata has been read in or if the setting for recording clip metadata has been turned off Same as GLOBAL CLIP ID (UMID data) TYPE2 USER CLIP NAME to be recorded If clip metadata has been read in Uploaded data + COUNT value* If no clip metadata has been read in or if the setting for recording Same as CLIP NAME clip metadata has been turned off * The COUNT value is indicated as a four-digit number. The COUNT value is incremented each time a new clip is captured if clip metadata has been read in and TYPE2 has been selected as the recording method. The COUNT value can be reset using the following procedure. Select META DATA  PROPERTY from the thumbnail menu, then select USER CLIP NAME to display the menu shown below. Select "COUNT RESET" with the cursor and press the SET button to reset the COUNT value to 1. Note When a P2 card with a memory capacity of 8 GB or more is used in unit and a one-time continuous recording exceeds the prescribed duration (DVCPRO HD and the AVCIntra100: about 5 minutes; AVC-Intra50: about 10 minutes) or when a one-time recording extends over more than one P2 card, the recording concerned will automatically be undertaken as a separate clip. At this time, each clip will be provided with its own COUNT value. Example of recording (DVCPRO HD) a clip on one P2 card: Recording start Recording pause Recording duration = Approx. 7 min Clip 1 COUNT value = 0001 Clip 2 COUNT value = 0002 Approx. 5 min Approx. 2 min Example of recording a clip on two P2 cards: Recording start Recording pause Clip 1 COUNT value = 0003 Clip 2 COUNT value = 0004 1st card 2nd card If the clip thumbnails are displayed as shown in the example above or their properties are indicated using a P2 device, the thumbnail and COUNT value of clip 1 will be displayed. Clear the uploaded metadata Select META DATA  INITIALIZE from the thumbnail menu, and press the SET button. Select YES when the confirmation screen is displayed. Notes Japanese or Chinese characters indicated in English or other characters that cannot be indicated in English will not display properly; they will be indicated as . The letters which can be input with the unit are only the alphanumeric. The unit cannot input Japanese and Chinese. 133 Manipulating Clips with Thumbnails: Setting of Clip Meta Data