Panasonic AJHPX2700G AJHPX2700G User Guide - Page 142
Connection with external devices using the USB 2.0 port
View all Panasonic AJHPX2700G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 142 highlights
Connection with external devices using the USB 2.0 port Connection with a PC in the USB DEVICE mode By connecting the unit with an external PC using USB 2.0, the P2 card inserted to the unit can be used as a mass storage device. Procedures for establishing a connection with a PC 1 Connect the USB cable to the USB 2.0 port. Notes The USB 2.0 cable is not included with the unit. Please use a commercially available USB 2.0 cable (shield with a ferrite core). Although the unit supports USB cables up to 5 meters long, cables up to 3-meters long are recommended. Notes A USB driver must be installed on the PC. The unit is only applicable to USB 2.0. Use a PC that supports USB 2.0. Only one unit at a time must be connected to the PC via USB. The P2 card must not be removed when it is connected via USB. While a USB connection is established, the P2 card's access LED should not be lit except when access is being carried out. When a USB device is active, recording, playback, or navigation through clip thumbnails is disabled. During a USB connection, the USB LED on the side panel stays illuminated. Also, "USB DEVICE" is displayed in the system information/warning area in the viewfinder. When the connection is not correctly established, both of these indications blink. a a. USB 2.0 port (DEVICE) 2 Navigate the menu to open the screen on the SYSTEM SETTING page. Then, set the PC MODE SELECT menu option to "USB DEV." and the PC MODE option to "ON". Note The function of the menu option PC MODE may be assigned to a desired user button by using any one of the menu options USER MAIN SW, USER1 SW, USER2 SW, MARKER SEL or TEXT MEMO SW. These options can be found in the screen on the CAM OPERATION page. When you establish the USB connection for the first time, install the supplied P2 software on the PC. Refer to the Installation Manual for the details. b b. USB LED 3 There are two ways to terminate the USB mode, as follows: Turn the POWER switch of the unit [OFF]. Set the PC MODE item to "OFF" from the menu operations. 142 Connection with external device: Connection with external devices using the USB 2.0 port