Panasonic AJHPX2700G AJHPX2700G User Guide - Page 160
Maintenance and Inspections: Warning System, Message, Description, Measure
View all Panasonic AJHPX2700G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 160 highlights
Item HDD (USB HOST mode) Message HDD CAPACITY FULL! TOO MANY PARTITIONS! HDD DISCONNECTED! CANNOT FORMAT! TOO MANY TARGETS! UNKNOWN DEVICE CONNECTED! CANNOT ACCESS TARGET! CANNOT RECOGNIZE HDD! CANNOT ACCESS CARD! MISMATCH COMPONENT! P2 CARD IS UNFORMATTED! CARD IS EMPTY! CANNOT COPY! VERIFICATION FAILED! PLEASE FORMAT P2 CARD! Description Not enough space left on the hard disk. There are too many partitions. The unit is not connected to a hard disk. The hard disk cannot be initialized. Multiple devices are connected. The connected DVD drive is not compatible. An error occurred during hard disk access. The destination target cannot be properly recognized. An error occurred during P2 card access. Copying is not possible since the model number of the destination card does not match that of the source card. The P2 card is not formatted. The P2 card selected for copying is empty. The compare check after copying failed. This warning indicates that data could not be imported from a hard disk to a P2 card because the P2 card contained recorded data. Measure There is not enough space on the connected hard disk. Use a new hard disk or formatted hard disk. Hard disks can handle up to 23 partitions. Use a new hard disk or formatted hard disk. Reconnect the USB cable. If the hard disk does not operate normally, turn it off and turn it back on again. Connect another hard disk drive. Disconnect devices, turn off the unit and turn it back on again. Disconnect devices, turn off the unit and turn it back on again. Check hard disk status and connection. Reboot the hard disk or connect a different hard disk. Check P2 card. Use a P2 card with the same model number or import video in clip units. Use a formatted P2 card. Copying is not performed since the card is empty. Copy the data again. You cannot copy to a P2 card that contains data. Format the card on a P2 device and copy again. 160 Maintenance and Inspections: Warning System