Panasonic AJHPX2700G AJHPX2700G User Guide - Page 155
Warning System, Warning Description Tables
View all Panasonic AJHPX2700G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 155 highlights
Maintenance and Inspections Warning System Warning Description Tables If a problem is detected immediately after the power is turned on, or during operation, this will be indicated by the WARNING lamp, lamps inside the viewfinder and a warning tone. Note The WARNING lamp has the highest priority, followed by the tally lamp, and then the warning tone. When multiple errors occur simultaneously a higher priority indication will be triggered. The [WIRELESS-RF], however, may not be indicated, depending on the menu setting. 1. System Errors Display window indication The error code lights up. WARNING lamp Blinks 4 times per second. Tally lamp Blinks 4 times per second. Viewfinder The "SYSTEM ERROR" indication and the error code light up. Warning tone Beeps continuously. Warning description An error in the reference signal or the communication. Recording/playback operation The operation stops. Countermeasures Please confirm [Error Codes] (page 158) and consult your distributor. 2. Card removal error Display window indication Error code "E-30" blinks. WARNING lamp Blinks 4 times per second. Tally lamp Blinks 4 times per second. Viewfinder The "TURN POWER OFF" indicator lights up. Warning tone Continues to beep. The P2 card being accessed has been Warning description removed, resulting in an error in the internal memory of the unit. Recording/playback operation Cannot be performed. Countermeasures Turn off the power to the unit. If there is an error in a clip on the removed P2 card, repair the clip. 3. Battery Empty Display window indication All 7 bar indicators for battery remaining capacity start blinking. WARNING lamp Lights up. Tally lamp Blinks once per second. Viewfinder The BATT LED lights up. Warning tone Beeps continuously. Warning description The battery has run out. Recording/playback operation The operation stops. Countermeasures Replace the battery. 4. P2 Card Fully Recorded Display window indication All 7 bar indicators for remaining MEDIA capacity start blinking. WARNING lamp This lamp will illuminate continuously until an operation is made after recording. Tally lamp This lamp will flash 4 times every second until an operation is made after recording. Viewfinder The "END" indicator blinks. When a write protected P2 card has been inserted, the "WP" indicator lights up. Warning tone This tone will sound continuously until an operation is made after recording. Warning description The P2 cards are recorded to maximum capacity. Recording/playback operation The recording stops. Countermeasures Delete the clips in the P2 card or insert a new P2 card. 5. Image Sequence Error (24P, 30P, 25P) Display window indication "E-40" appears in the time code display field. WARNING lamp Blinks 4 times per second. Tally lamp Blinks 4 times per second while recording continues. Viewfinder The "REC WARNING" indicator lights up. Warning tone Beeps 4 times per second while recording continues. There are abnormal conditions in the Warning description image sequence of the 24P, 30P, or 25P mode. Recording/playback operation Images can be recorded and played back, but some frames may be dropped or the sequences of TC and UB may shift. Countermeasures Confirm the recording/playback operation after turning off the power supply once and then turning it on again. If the error is not corrected after executing this procedure, contact the dealer. Maintenance and Inspections: Warning System 155