Panasonic AJHPX2700G AJHPX2700G User Guide - Page 82

Information Item 36. B.GAMMA RANGE 37. Switch lock setting 38. Exposure Indication Indication 1 2 3 !SW LOCK -4 -3„„ -3„ -3 -2„„ -2„ -2 -1„„ -1„ -1 ±0 +0„ +0„„ +1 +1„ +1„„ +2 +2„ +2„„ +3 +3„ +3„„ +4 +4„ +4„„ +5 Status This indicates the level (upper limit) of the compression/expansion. This is displayed when any of the side switches (GAIN, OUTPUT and AWB switches) are operated with SIDE SW LOCK in a locked state. Note that it is not displayed during when AJ-RC10G is connected and in operation. When GAMMA MODE SEL has been set to "FILM-REC" and STATUS MODE to "FILM REC", executing the Y GET operation measures brightness in proximity to the center marker. The measured value is displayed as an exposure level. A measured output signal of 30% is displayed as ±0 (normal). This value is then adjusted by +1 STOP for every doubling of the amount of incident light and by -1 STOP for every halving of the amount incident light. Each „ represents 1/3 STOP. GAMMA MODE SEL is set from the screen of the PAINT page. STATUS MODE is set from the screen of the VF page. P2 Card Remaining Free Space/capacity Indication Status of unit Recording status Under normal Other than conditions LOOP REC mode LOOP REC mode During MODE Other than CHECK LOOP REC mode LOOP REC mode Menu option P2CARD REMAIN*1 TOTAL ONE-CARD OFF TOTAL/ONE-CARD OFF TOTAL/ONE-CARD/ OFF 5. P2 card remaining free space indication*2 6. P2 card remaining free space indication (during MODE CHECK)*2 The total remaining free space of all P2 cards loaded in the P2 card slots is indicated in minutes. Example: 30min Not provided The number of the P2 card slot holding the Not provided target P2 card, together with that card's remaining free space indicated in minutes. Example: 8min Not provided Not provided Indicated as "LOOP" Not provided Not provided Not provided The total remaining free space and capacities of all P2 cards loaded in the P2 card slots are indicated in minutes. Example: 20/40 The number of the P2 card slot holding the target P2 card, together with that card's remaining free space, indicated in minutes. Example: 8min Indicated as "LOOP" The estimated recording time is indicated in minutes. Example: 7min *1 The menu option P2CARD REMAIN can be found in the screen on the VF page. *2 If the remaining free space or memory capacity is 9999 min or more, [9999min] is displayed. 82 Adjustments and Settings for Recording: Viewfinder Screen Status Displays