Panasonic AJHPX2700G AJHPX2700G User Guide - Page 156
Recording Error, Low Wireless Signal Reception, Error, Battery Nearly Empty, P2 Card Nearly Full
View all Panasonic AJHPX2700G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 156 highlights
6. Recording Error Display window indication "00:00:00:11" appears in the time code display field. Even after recording is stopped, this display continues to blink until the next operation is performed. WARNING lamp Blinks 4 times per second while recording continues. Tally lamp Blinks 4 times per second while recording continues. Viewfinder The "REC WARNING" indicator lights up. Warning tone Beeps 4 times per second while recording continues. Warning description This indicates a failure either in the P2 card recording or the recording circuit. This is displayed when attempting to record clips where the total quantity exceeds the upper limit (1000 pieces) for a single P2 card. Recording/playback operation The recording may stop or continue. Countermeasures Confirm the recording/playback operation after turning off the power supply once and then turning it on again. If the recording cannot be performed normally, change the P2 card. 7. Low Wireless Signal Reception Display window indication No display. WARNING lamp Blinks 4 times per second (during pause and recording). Tally lamp Blinks 4 times per second while recording continues. Viewfinder The "WIRELESS-RF" indicator lights up while recording continues. Warning tone Beeps 4 times per second while recording continues. Warning description This error indicates poor wireless audio reception conditions. Recording/playback Continues to operate without receiving operation the wireless microphone signal. Countermeasures Check the microphone power supply and the reception status of the wireless receiver. 8. 1394 Error Display window indication The "1394 E-92" indicator in the display window blinks. WARNING lamp Blinks 4 times per second while recording continues. Tally lamp Blinks 4 times per second while recording continues. Viewfinder "1394 INITIAL ERROR" indicator lights up (during pause and recording). Warning tone Beeps 4 times per second while recording continues. Warning description This indicates a failure of the DVCPRO connector. Recording/playback operation Signals cannot be controlled or supplied to the device connected to the DVCPRO connector. However, recording and playback can be performed on the unit. Countermeasures Check the connection between the IEEE1394 cable and the DVCPRO connector, settings of any external device and menus, and the turn on the power again. If the warning indication is still illuminated, consult your distributor. 9. Battery Nearly Empty Display window indication One of the bars in the battery remaining indicator starts blinking. WARNING lamp Blinks once per second. Tally lamp Blinks once per second. Viewfinder The "BATT" LED blinks. Warning tone Beeps 4 times per second. Warning description The battery is about to run out. Recording/playback operation Continues to operate. Countermeasures Replace the battery as required. 10. P2 Card Nearly Full Display window indication One of the bars for remaining MEDIA capacity starts blinking. WARNING lamp Blinks once per second while recording continues. Tally lamp Blinks once per second while recording continues. Viewfinder The P2 card remaining capacity indicator blinks. Warning tone Beeps once per second while recording continues. Warning description The total remaining capacity of all the P2 cards is 2 minutes or less. Recording/playback operation Continues to operate. Countermeasures Replace the cards. If there is an empty card slot, insert a new card. 156 Maintenance and Inspections: Warning System