Panasonic AV-UHS500 4K Switcher Operating Instructions - Page 57

Basic operations Selecting the DSK material Selecting the DSK fill signal and DSK source signal Press the [DSK] button in the AUX bus selection area to switch the selection of the DSK fill signal (indicator lights in amber) and DSK source signal (indicator lights in green). While the indicator of the [DSK] button is lit in amber, press one of the AUX bus crosspoint buttons 1 to 12 to select the DSK fill signal. The indicator of the selected AUX bus crosspoint button lights in amber. (It lights in red if the selected signal is being output from the PGM connector.) KEY1 F/S KEY2 F/S KEY3 F/S DSK1 F/S DSK2 F/S AUX1 AUX2 AUX3 AUX4 DISP CAM AMBER : FILL / GREEN : SOURCE AUX BUS DELEGATION AUX MV1 PGM MV2 PVW AUX /DISP SOURCE SHIFT Lighting in amber While the indicator of the [DSK] button is lit in green, press one of the AUX bus crosspoint buttons 1 to 12 to select the DSK source signal. The indicator of the selected AUX bus crosspoint button lights in green. (It lights in red if the selected signal is being output from the PGM connector.) Since the luminance key is operated as a self key, the key fill signals are used as the key source signals. When the luminance key has been selected as the downstream key type, the key signals will remain unchanged even when the key source signals are switched. KEY1 F/S KEY2 F/S KEY3 F/S DSK1 F/S DSK2 F/S AUX1 AUX2 AUX3 AUX4 DISP CAM AMBER : FILL / GREEN : SOURCE AUX BUS DELEGATION AUX MV1 PGM MV2 PVW AUX /DISP SOURCE SHIFT Lighting in green Linking the DSK fill signal and DSK source signal selection 1 Press the CONF SYS button to light it, and display the Config menu. 2 Use [F1] to display the Key Signal Coupling1 sub menu. 3 Use [F2] to select the linking method for the DSK fill signal and DSK source signal by using the Fill/Source item. Fill To Source When the DSK fill signal is selected, the DSK source signal changes automatically. Source To Fill When the DSK source signal is selected, the DSK fill signal changes automatically. When the DSK fill signal is selected, the DSK source signal also switches automatically. Initially, the DSK source signal and the DSK fill signal will be the same signal. For example, when "SDI1" is selected for the DSK fill signal, the DSK source signal also becomes "SDI1". After that, when the [DSK] button is pressed and lights in green, "SDI2" is selected for the DSK source signal. At this time, combination data indicating that the DSK fill signal is "SDI1" and the DSK source signal is "SDI2" is recorded on the unit. After the DSK fill signal and DSK source signal have been switched to other signals to perform another operation, if the DSK fill signal is then selected and set to "SDI1", the saved combination data causes the DSK source signal to automatically switch to "SDI2". If the DSK source signal is changed while the DSK fill signal is set to "SDI1", the combination data is updated to reflect the change, and is recorded on the unit. When the DSK source signal is selected, the DSK fill signal switches automatically. However, be aware that if the [DSK] button is pressed when it is not lit, the [DSK] button will first light green, and the mode will be that for selecting the DSK source signal. 57