Pioneer 141FD Owner's Manual - Page 14
Consult with your dealer or professional - pro stand
UPC - 012562905761
View all Pioneer 141FD manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
02 Install Your Flat Panel Display 2.2.1 Check the Location for Suitability When choosing the location for your panel, there are several factors to keep in mind. The installation site should be out of direct sunlight and have sufficient ventilation around the flat panel display to allow cooling. The diagram below is an example of a stand-mounted panel with proper ventilation. Over 10 cm (3 15/16 inches) Over 50 cm (19 11/16 inches) The distance behind and above the panel changes depending on your choice of mount. Consult with your dealer or professional installer for proper ventilation. Use the checklist below to judge possible installation sites. Sufficient ventilation Safe from excessive vibrations Away from air conditioners Free of moisture or dampness No danger of splashing water Route cords and cables safely No danger of power overloads Separate from other IR equipment Protected from hits or shocks Distance from heat sources Out of direct sunlight Away from strong lighting sources For specific cautions and safety information, refer to "8.2 Physical Location & Temperature Considerations" and "8.8 Safety Precautions." 2.2.2 Lift and/or Move Your Panel (the How To's) This flat panel display is built for endurance but because of the technology, the panel must be handled with care. Use the handles attached to the rear of the flat panel display to lift the unit. To avoid flexing or twisting the unit, you need at least two people to lift and move the panel. Do not move the flat panel display by holding only a single handle or by dragging the panel by its handles. (PRO-141FD) (PRO-101FD) Note: Do not use the handles to hang the flat panel display or as anchors to prevent the panel from slipping or 14 tipping after it is mounted. En