Sharp MX 4501N Installation Manual - Page 12

5) After entering the data, close the front cabinet. 2) Remove the heat seal. 6) Select K, C, M, Y and then press the [EXECUTE] button. The system then performs the simulation, samples the toner density control sensor value, and sets (stores in memory) the average sensor detection level as the control level for the reference toner density. TEST SIMULATION NO.25-02 AUTOMATIC DEVELOPER ADJUSTMENT AT DEVE ADJ_L_K : 128 AT DEVE VO_L_K : 128 AT DEVE ADJ_L_C : 128 AT DEVE VO_L_C : 128 AT DEVE ADJ_L_M : 128 AT DEVE ADJ_L_Y : 128 K C M Y AT DEVE VO_L_M : 128 AT DEVE VO_L_Y : 128 EXECUTE 0 CLOSE 1/2 Note: Be sure to select all of the four colors: K, C, M, Y. 7) Exit from Simulation mode by pressing the [CA] key on the main unit. 3) Open the front cover, and insert each toner cartridge. * Be sure to install the color cartridges to their proper positions. Avoid installation to a different color position. * Do not forcibly insert the toner cartridge. Keep holding the cartridge and completely insert it. * When the machine is transported with the developing unit removed, be sure to remove the toner cartridge. (If not, tone may be clogged.) [Color toner cartridge positions] Y M C BK G. Installation of individual color toner cartridges * The life of each toner cartridge is as follows: Black toner cartridge: equivalent to approximately 18K (A4/LT 5%) Color toner cartridge: equivalent to approximately 15.0K (A4/LT 5%) 1) Shake the toner cartridge (package part No. 1) horizontally several times. 4) Insert the cartridge securely until it locks. MX-3500N/4500N, MX-3501N/4501N 1 - 9