Sharp MX 4501N Installation Manual - Page 8
Applying titanium hydroxide - remove roller
View all Sharp MX 4501N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
4 : Nov. 15 2006 5) Loosen the blue screw. 4 D. Applying titanium hydroxide 1) Remove the cleaner unit. 6) Turn the blue screw (A) counterclockwise. Check to insure that the lock is released as shown with (B), and pull out the primary transfer unit toward you. * If this procedure is not executed, the intermediate transfer belt may be damaged. B A * Since titanium hydroxide is of fine powder, it may disperse when removing from the bag. To prevent against dispersion, remove it from the bag at a lower position. * Pushing the bag lightly against the belt provides sufficient application of titanium hydroxide. Lift the bag from the application surface by 5 mm or less. * Apply titanium hydroxide before installing the cleaner unit. 2) Install the primary transfer UN with its backside facing upward and remove the cleaner frame UN. 7) Remove the transfer belt protect sheet horizontally in the arrow direction. 3) Apply titanium hydroxide to the belt within approx. 15 cm from the driving roller. Driving roller 15cm MX-3500N/4500N, MX-3501N/4501N 1 - 5