Sharp MX 4501N Installation Manual - Page 16
Printer color balance adjustment, Auto adjustment
View all Sharp MX 4501N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
4 : Nov. 15 2006 4 4) Press [FACTORY] key, and press [EXECUTE] key. TEST SIMULATION NO. 46-24 ENGINE HALFTONE AUTO ADJUSTMENT 0 CLOSE PLEASE SELECT THE MODE (FACTORY) OR (SERVICE) AND PLACE THE PRINTED TEST PATCH ON DOCUMENT GLASS THEN PRESS [EXECUTE]. , 㪁LIGHT AREA AT LEFT SIDE ON DOCUMENT GLASS. FACTORY SERVICE EXECUTE The copy color balance adjustment is automatically executed and prints the color balance check patch image. 5) Press [OK] key. TEST SIMULATION NO. 46-24 ENGINE HALFTONE AUTO ADJUSTMENT CONFIRM THE ADJUSTED PATCH AND PRESS [OK] TO REGISTER THIS PATCH DATA ,PRESS [REPEAT] TO CONTINUE THIS PROCEDURE. 0 CLOSE REPEAT OK Note: Do not cancel the simulation until "PLEASE QUIT THIS MODE" is displayed. TEST SIMULATION NO. 46-24 ENGINE HALFTONE AUTO ADJUSTMENT COMPLETED THIS PROCEDURE. PLEASE QUIT THIS MODE. 0 CLOSE (5) Printer color balance adjustment (Auto adjustment) a. Note for execution of the color balance adjustment (Auto adjustment) • The copy color balance adjustment must have been completed properly. • Be sure to use the specified paper for color. b. Adjustment procedure 1) Enter the SIM 67-24 mode. TEST SIMULATION NO.67-24 PRINTER ENGINE HALFTONE AUTO ADJUSTMENT MODE PRESS [EXECUTE] TO PROCON EXECUTION AND PRINT THE TEST PATCH. (PLEASE USE SPECIFIED TYPE OF A3 OR 11"17" SIZE PAPER FOR THIS ADJUSTMENT 0 CLOSE EXECUTE 2) Press [EXECUTE] key. (A3 or 11" x 17" paper is automatically selected.) The color patch image (adjustment pattern) is printed out. 3) Set the color patch image (adjustment pattern) paper printed on the document table. Place the printed color patch image (adjustment pattern) paper so that the thin lines on the paper are on the left side. At this time, place 5 sheets of white paper on the printed color patch image (adjustment pattern) paper. PRINTER CALIBRATION 6) Check the color balance and density. Check to insure that the printed color balance check patch image is within the following specifications. Low density Y M C Bk Fig. 1 PG image High density A B C D E F G H I J K L M N O Max Patch A of each of Y, M, C, and BK are not copied. 2) Patch C or D of each of Y, C, M, and BK is very slightly copied. 1) The max. density section is not blurred. 3) Patch for each of C, M, Y, BK The patch density is identical between patches or not reversed. The patch density is changed gradually. The print density must be changed gradually from the lighter level to the darker level. The density changing direction must not be reversed. The density level of each color must be almost at the same level. Patch B may not be copied. Patch A must not be copied. 4) Press [FACTORY] key, and press [EXECUTE] key. TEST SIMULATION NO.67-24 PRINTER ENGINE HALFTONE AUTO ADJUSTMENT MODE 0 CLOSE PLEASE SELECT THE MODE (FACTORY) OR (SERVICE) AND PLACE THE PRINTED TEST PATCH ON DOCUMENT GLASS THEN PRESS [EXECUTE]. , 㪁LIGHT AREA AT LEFT SIDE ON DOCUMENT GLASS. FACTORY SERVICE EXECUTE The copy color balance adjustment is automatically executed and prints the color balance check patch image. Wait until the operation panel shown in the next procedure is displayed. MX-3500N/4500N, MX-3501N/4501N 1 - 13