Symantec 10490452 Administration Guide - Page 189

Administering the system 189 Managing Scanners Editing Scanners Once you set up a Scanner, you can go back and edit the configuration. For example, you can suspend the flow of mail or enable different components and services. Edit a scanner Follow either of these procedures to edit a scanner. To edit a Scanner 1 In the Control Center, click Settings > Hosts. 2 Check the host to edit. 3 Click Edit. 4 Make any changes to the host or its included components and services. From this page, you can: ■ Start and stop services ■ Start and stop the flow of data to and from a Scanner. ■ Enable and disable Scanner replication ■ Alter Conduit proxy settings ■ Define SMTP settings ■ Define internal mail servers for your site For more details on these categories, see "Configuring host (Scanner) settings" on page 20. To edit a Scanner (alternative method) 1 In the Control Center, click Status > Host Details. 2 Select a host from the drop-down list. 3 Click Configure Host. 4 Make any changes to the host or its included components and services. See "To edit a Scanner" on page 189 for a list of the types of changes you can make. Enabling and disabling Scanners For troubleshooting or testing purposes, you can disable and then re-enable Scanners. Also, It is strongly recommended that you disable a Scanner before deleting it. Otherwise, you run the risk of losing email messages within the Scanner email queues. Bear in mind that a Scanner will not process mail while it is disabled.