Symantec 10490452 Administration Guide - Page 27

Configuring system settings 27 Configuring host (Scanner) settings Table 2-3 SMTP delivery advanced setting descriptions Item Description Maximum number Sets the maximum number of connections allowed to all defined of connections to all internal mail servers. Any additional connection attempts are internal mail servers rejected. The default is 100 internal mail server connections. Maximum number of connections per single internal mail server Sets the maximum number of connections to one internal mail server. Any additional attempt to make a connection is rejected. The default is 50 connections. Minimum retry interval Sets the smallest interval the SMTP server waits before trying to deliver a message again. The default is 15 minutes. Sent message time- Sets the time after which a undelivered message times out and is out rejected from the queue. The default is 5 days. Message delay time in queue before notification Sets the time a message waits in the mail queue before notification of nondelivery is sent. The default is 4 hours. Enable TLS encryption Allows TLS encryption when checked. If unchecked, TLS encryption is not performed. By default, TLS encryption is not enabled. To set up the SMTP Advanced Configuration 1 From the Control Center, click Settings > Hosts. 2 Select a Scanner from the displayed list. 3 Click Edit. 4 Click the SMTP tab. On this page, you will see some general-purpose settings described in "SMTP Scanner settings" on page 22. 5 Click Advanced Settings. On this page you will see some advanced Scanner configuration SMTP settings. These settings are fully described in "Advanced SMTP settings" on page 25. 6 As appropriate, modify the settings explained above. 7 Click Save to store your information. You are returned to the main SMTP configuration page. 8 Click Save.