TP-Link TL-SL5428E User Guide - Page 108

TL-SL5428E 24-port 10/100Mbps + 4-port Gigabit L2 Managed Switch CLI Guide buffer | flash -The output channels: buffer and flash. Clear the information of the two channels, by default. Command Mode Global Configuration Mode Example Clear the information in the log file: TP-LINK(config)# logging clear buffer logging loghost Description The logging loghost command is used to configure the Log Host. To clear the configuration of the specified Log Host, please use no logging loghost command. Log Host is to receive the system log from other devices. You can remotely monitor the settings and operation status of other devices through the log host. Syntax logging loghost index {idx} {host-ip} {level} { disable | enable } no logging loghost index {idx} Parameter idx --The index of the log host. The switch supports 4 log hosts. host-ip -- The IP for the log host. level --The severity level of the log information sent to each log host. There are 8 severity levels marked with values 0-7. The smaller value has the higher priority. Only the log with the same or smaller severity level value will be sent to the corresponding log host. By default, it is 6 indicating that the log information marked with 0~6 will be sent to the log host. disable | enable --Disable or enable the log host. By default, it is disabled. Command Mode Global Configuration Mode Example Enable the log host 2 and set the IP address 192.168.0.148, the level 5: 96