TP-Link TL-SL5428E User Guide - Page 59
LACP Commands, lacp, lacp (interface)
UPC - 845973020873
View all TP-Link TL-SL5428E manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 59 highlights
TL-SL5428E 24-port 10/100Mbps + 4-port Gigabit L2 Managed Switch CLI Guide Chapter 10 LACP Commands LACP (Link Aggregation Control Protocol) is defined in IEEE802.3ad and enables the dynamic link aggregation and disaggregation by exchanging LACP packets with its partner. The switch can dynamically group similarly configured ports into a single logical link, which will highly extend the bandwidth and flexibly balance the load. lacp Description The lacp command is used to enable the LACP function globally. To disable the LACP function, please use no lacp command. Syntax lacp no lacp Command Mode Global Configuration Mode Example Enable the LACP function globally: TP-LINK(config)# lacp lacp (interface) Description The lacp(interface) command is used to to enable LACP protocol on the current port. To disable LACP protocol, please use no lacp command. Syntax lacp no lacp Command Mode Interface Configuration Mode(interface ethernet / interface range ethernet) 47