TP-Link TL-SL5428E User Guide - Page 53

TL-SL5428E 24-port 10/100Mbps + 4-port Gigabit L2 Managed Switch CLI Guide no gvrp timer [leaveall | join | leave] Parameter leaveall | join | leave -- They are the three timers: leave All、join and leave. Once the LeaveAll Timer is set, the port with GVRP enabled can send a LeaveAll message after the timer times out, so that other GARP ports can re-register all the attribute information. After that, the LeaveAll timer will start to begin a new cycle. To guarantee the transmission of the Join messages, a GARP port sends each Join message two times. The Join Timer is used to define the interval between the two sending operations of each Join message. Once the Leave Timer is set, the GARP port receiving a Leave message will start its Leave timer, and unregister the attribute information if it does not receive a Join message again before the timer times out. value --The value of the timer. The LeaveAll Timer ranges from 1000 to 30000 centiseconds and the default value is 1000. The Join Timer ranges from 20 to 1000 centiseconds and the default value is 20. The Leave Timer ranges from 60 to 3000 centiseconds and the default value is 60. Command Mode Interface Configuration Mode（interface ethernet / interface range ethernet） Example Set the GARP leaveall timer of port 6 to 2000 centiseconds and restore to the join timer of it to the default value: TP-LINK(config)# interface Ethernet 6 TP-LINK(config-if)# gvrp timer leaveall 2000 TP-LINK(config-if)# no gvrp timer join show gvrp global Description The show gvrp global command is used to to display the global GVRP status. Syntax show gvrp global Command Mode Any Configuration Mode 41