Thermador PRD48JDSGU Use and Care Manual - Page 8
IMPORTANT, Electrical Rating, WARNING, CAUTION, WARNING - ALL MODELS - parts
View all Thermador PRD48JDSGU manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
IMPORTANT: All ranges must be installed with a back guard. For island installations and other installations with more than 12" (305 mm) minimum horizontal clearance between combustible materials and the back edge of the range, a Flush Island Trim has been supplied with the range. A THERMADOR® Lowback or Highshelf must be purchased separately and utilized when there is less than a 12" (305 mm) horizontal clearance. Before using the range, insure that it is equipped with a proper back guard. Refer to the Installation Instructions accompanying this appliance for more information. Electrical Rating: 240/208 volts, 60 Hz., 50 Amp electrical circuit required. WARNING: To avoid possible burn or fire hazard, a back guard designed specifically for this range must be installed whenever the range is used. CAUTION: The high shelf can get very hot! DO NOT place the following items on top of the high shelf: • plastics or containers that can melt • flammable items • a total load over 30 lbs. (13.6 kg). WARNING: ALWAYS DISCONNECT THE ELECTRICAL PLUG FROM THE WALL RECEPTACLE BEFORE SERVICING THIS UNIT. It is recommended that a dedicated circuit servicing this appliance be provided. The use of gas cooking appliances results in the production of heat and moisture. CAUTION: FOR PERSONAL SAFETY, THIS APPLIANCE MUST BE CONNECTED TO A PROPERLY GROUNDED AND POLARIZED ELECTRICAL POWER SUPPLY. See Installation Instructions for electrical requirements and grounding instructions. It is the personal responsibility and obligation of you, the user, to have this appliance connected to the electrical power supply by a qualified electrician, in accordance with the National Electrical Code and/or applicable local codes and ordinances. WARNING - ALL MODELS: IN CASE OF AN ELECTRICAL FAILURE If for any reason a gas control knob is turned ON and there is no electrical power to operate the electronic igniters on the range's cooktop STAR® burners, turn OFF the gas control knob and wait 5 minutes for the gas to dissipate before lighting the STAR® burner manually. To light the STAR® burners manually, carefully hold a lighted match to the STAR® burner ports and turn the gas control knob to HI. During a power failure, you can use the standard cooktop STAR® burners, but each must be lit with a match. DO NOT attempt to light the two left XLO® STAR® burners and two right XLO® STAR® burners manually. These STAR® burners are equipped with the ExtraLow® feature and cannot be lit manually. TESTED IN ACCORDANCE WITH: • ANSI Z21.1 for Household Gas Appliances • UL858 for Household Electric Ranges • CAN/CSA-22.2 No. 61-M89 for Household Cooking Ranges • CAN/CGA 1.1-M81 Domestic Gas Ranges Check your local building codes for the proper method of installation. In the absence of local codes, this unit should be installed in accordance with the National Fuel Gas Code No. Z223.1 current issue and the National Electrical Code ANSI/NFPA No. 70 current issue or the Can - B149 Installation Codes for Gas Burning Appliances and C22.1 Canadian Electrical Code Part 1. It is the responsibility of the owner and the installer to determine if additional requirements and/or standards apply to specific installations. English 4