ZyXEL WAP3205 User Guide - Page 117
Internet Access
View all ZyXEL WAP3205 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 117 highlights
Chapter 13 Troubleshooting 5 Reset the device to its factory defaults, and try to access the WAP3205 with the default IP address. See Section 12.7 on page 110. 6 If the problem continues, contact the network administrator or vendor, or try one of the advanced suggestions. Advanced Suggestion • If your computer is connected wirelessly, use a computer that is connected to a LAN port. I can see the Login screen, but I cannot log in to the WAP3205. 1 Make sure you have entered the password correctly. The default password is 1234. This field is case-sensitive, so make sure [Caps Lock] is not on. 2 This can happen when you fail to log out properly from your last session. Try logging in again after 5 minutes. 3 Disconnect and re-connect the power adaptor or cord to the WAP3205. 4 If this does not work, you have to reset the device to its factory defaults. See Section 13.4 on page 118. 13.3 Internet Access I cannot access the Internet. 1 Check the hardware connections, and make sure the LEDs are behaving as expected. See the Quick Start Guide. 2 Make sure the WAP3205 is connected to a broadband modem or router with Internet access. 3 If you are trying to access the Internet wirelessly, make sure the wireless settings in the wireless client are the same as the settings in the AP. • Go to Network > Wireless LAN > General > WDS and check if the WAP3205 is set to bridge mode. Select Disable and try to connect to the Internet again. 4 Disconnect all the cables from your device, and follow the directions in the Quick Start Guide again. 5 Go to Maintenance > Sys OP Mode. Check your System Operation Mode setting. • Select Access Point Mode if your WAP3205 bridges traffic between clients on the same network. • Select Client Mode if your WAP3205 needs a wireless client to connect to an existing access point. WAP3205 User's Guide 117