Brother International DCP-1400 Service Manual - Page 56

4) At the front end of the document feed roller shaft, remove the pawled bushing by pulling its pawls outwards. At the rear end, pull the bushing outwards and lift up the document feed roller ASSY. 5) At the front end of the upper LF roller (gray) shaft, remove the pawled bushing by pulling its pawls outwards. At the rear end, pull the bushing outwards and lift up the upper LF roller ASSY. 6) Remove the two screws and take off the ADF motor. Bushing Document feed roller ASSY Screw, pan (washer) M3x6DA ra , ADF motor fa , Upper LF rollerASSY (gray) Anti-static brush Upper ADF chute (Front) Pawled bushings If you do not need to remove the ADF parts, skip to step 10). 7) Peel off the ADF film. NOTE: Once removed, the ADF film will become unusable and a new part will have to be put back in. 8) Remove the screw and take off the spring plate A, separation rubber, rubber holder, and compression spring. 9) Push the hooks provided on the upper ADF chute and remove the pressure rollers and their springs. ADF film Spring plate A ADF parts Separation rubber Rubber holder Compression spring Hook Pressure rollers ;l - Taptite, pan B M3x6 Upper ADF chute Pressure roller springs Hook IV - 12 (Front)