Brother International DCP-1400 Service Manual - Page 57
Remove, screws, upper, chute., document, front, sensor, actuator, shown, below, Disconnect, harness
View all Brother International DCP-1400 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 57 highlights
10) Remove the two screws and lift up the upper ADF chute. Taptite, cup B M3x8 Upper ADF chute Lower ADF chute • 0 (Front) 11) Turn the document front sensor actuator as shown below and lift it up. 12) Turn the document rear sensor actuator as shown below and lift it up. 13) Disconnect the document sensor harness from the document sensor PCB and take out its harness from the harness guides. 14) Unhook the two latches (large and small latches in this order) from the document sensor PCB and lift it up. Routing the document sensor harness Harness guides Document rear sensor Gs. 0 Document sensor harness Document front sensor Document sensor PCB Document front sensor actuator a Lower ADF chute Document rear sensor actuator Large latch 0 Small latch (Front) IV - 13