Brother International Innov-is XJ2 Operation Manual - Page 136

THE 2-POINT EMBROIDERY POSITIONING FUNCTION c Select the pattern. d Touch to display the embroidery screen. e Touch and then touch . h Touch . i Select the direction (from the reference point) used as a reference for aligning the pattern. to be For this example, select the arrow pointing to the right as the reference direction. 1 1 Switch on/off the 2-point embroidery positioning function with a LED pointer. Memo • The LED pointer lights up to indicate the needle drop point. • When the LED pointer is turned on, the embroidery foot height is automatically adjusted according to the fabric thickness. • If the surface of the fabric is too uneven or rough, check and adjust the alignment of the light of the LED pointer and the needle drop point before starting to embroider. f If a message appears, indicating that the move and rotate settings will return to the original ones, touch . g From the the point reference points shown in to be used for aligning the the screen, pattern. select For this example, select the point in the lower-left corner of the pattern. 2 1 1 Cancel the pattern alignment settings. 2 Return to the previous screen. j Touch . k Touch the positioning keys to move the embroidery frame until the position of the LED pointer and the center of the first mark are aligned. To change the speed that the frame moves, use the frame movement speed keys. If it is difficult to make a precision alignment, touch a frame movement speed key for a slower speed. 1 2 1 Positioning keys 2 Frame movement speed keys d c 3 Center of the first mark 4 Light of the LED pointer 134