Brother International Innov-is XJ2 Operation Manual - Page 151
Using the Automatic Thread Cutting, Function End Color Trim
View all Brother International Innov-is XJ2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 151 highlights
MAKING EMBROIDERY ADJUSTMENTS Bobbin Thread Is Too Tight Upper thread on the right side of fabric seems to be lifting/ looping and bobbin thread is not seen on the wrong side of fabric. 1 Right side 2 Wrong side If this occurs, turn the slotted screw (-) counterclockwise, being careful not to over-loosen the screw, approximately 30-45 degrees to decrease bobbin tension. Using the Automatic Thread Cutting Function (End Color Trim) The automatic thread cutting function will cut the thread at the end of embroidering each color. This function is initially turned ON. To turn this function OFF, touch and then . * This setting returns to its default machine is turned off. when the a Touch . IMPORTANT • DO NOT adjust the position of the phillips (+) screw on the alternate bobbin case as this may result in damage to the bobbin case, rendering it unusable. • If the slotted screw (-) is difficult to turn, do not use force. Turning the screw too much or providing force in either (rotational) direction may cause damage to the bobbin case. Should damage occur, the bobbin case may not maintain proper tension. Note • When adjusting the alternate bobbin case, be sure to remove the bobbin from the alternate bobbin case. b Touch function. 5 to turn off the automatic thread cutting ADVANCED EMBROIDERY The key will display as . When one color thread is embroidered, the machine will stop without cutting the thread. 149