Brother International Innov-is XJ2 Operation Manual - Page 42
front to back. Using
View all Brother International Innov-is XJ2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 42 highlights
UPPER THREADING b Thread the machine for the first needle according to the procedure for threading a single needle ("Upper Threading" on page 36). f While holding the thread thread through the lower from the notch in spool, pull the the thread guide plate, then through the upper notch. Hold the end of the thread with your left hand, and then guide the thread through the groove, following the arrows in the illustration. c Pass the thread through the needle bar thread guides on the needle bar, then thread the needle on the left side manually. a g Continue threading; however, do not pass the thread the needle bar thread guide "6" on the needle bar. in Thread the needle on the right side. a 1 Needle bar thread guide IMPORTANT • (Automatic threading button) cannot be used. Manually thread the twin needle from front to back. Using (Automatic threading button) may result in damage to the machine. d Pull up the supplemental spool pin and set it in the up position. Place the additional spool of thread on the supplemental spool pin, so that the thread unwinds from the front. Push the spool cap onto the spool pin as far as possible to secure the thread spool. 1 Needle bar thread guide h Touch to unlock all keys and buttons. i Select a stitch pattern. * Refer to "Basic Sewing" on page 49 for selecting a stitch pattern. * Refer to "STITCH SETTING CHART" on page 197 for the proper stitch to use with presser foot "J". j Touch to select the twin needle mode. a 1 b c 1 Spool cap 2 Spool pin 3 Spool of thread e Hold the thread from the spool with place the thread in the thread guide. both hands, and * Do not place the thread in the pretension disks. a 1 Thread guide 40 1 Single needle/twin needle position setting display appears. CAUTION • Be sure to set the twin needle mode when using the twin needle. Using the twin needle while the machine is in single needle mode could cause the needle to break and cause injury.