Brother International Innov-is XJ2 Operation Manual - Page 14
Important
View all Brother International Innov-is XJ2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
INCLUDED ACCESSORIES Using the Multi-Purpose Screwdriver (Included with Some Models) Since the screwdriver can be changed to three different positions, it can be extremely useful for the various machine preparations. With this machine, position "1" and position "3" are used. Position "1" Position "3" You can install/remove the presser foot holder, needle clamp screw or needle plate. The multi-purpose screwdriver can be positioned over the screw on the embroidery frame to tighten the screw after hooping the fabric or when removing the fabric. IMPORTANT • Do not lift the handle of the machine while the spool stand is installed. • Do not push or pull the telescopic thread guide or spool pins with extreme force, otherwise damage may result. • Do not place any object other than spools of thread on the spool support. • Do not try to wind thread on the bobbin while sewing using the spool stand. How to Assemble the Spool Stand a Fully extend the telescopic thread guide shaft, and then rotate the shaft until the two internal stoppers click into place. Using the Spool Stand (Included with Some Models) The included spool stand is useful when using thread spools with a large diameter (cross-wound thread). The spool stand can hold two spools of thread. 1 2 3 b Insert at the the telescopic thread guide into center of the spool support, and the round hole then use a screwdriver to securely tighten the screw from the reverse side. 4 5 6 7 8 9 No. Part Name 1 Telescopic thread guide 2 Spool support 3 Spool pin × 2 4 Screw and washer 5 Spool cap (XL) × 2 6 Spool holder × 2 7 Spool cap base × 2 8 Spool felt × 2 9 Ring × 4 12 1 Screw Note • Make sure that the stoppers on the telescopic thread guide shaft are firmly in place and that the thread guide openings are directly above the two holes for spool pins in the spool support. In addition, check that the shaft is securely tightened in the spool support.