Brother International Innov-is XJ2 Operation Manual - Page 47
Changing The Presser Foot
View all Brother International Innov-is XJ2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 47 highlights
CHANGING THE PRESSER FOOT CAUTION • Always touch on the screen to lock all keys and buttons before changing the presser foot. If is not touched and the "Start/ Stop" button or another button is pressed, the machine will start and may cause injury. • Always use the correct presser foot for the selected stitch pattern. If the wrong presser foot is used, the needle may strike the presser foot and break, and may cause injury. • Make sure that the presser foot is installed in the correct direction, otherwise the needle may strike the presser foot, breaking the needle and causing injuries. CHANGING THE PRESSER FOOT f Raise the presser foot lever foot is securely attached. to check that the presser 1 GETTING READY g Touch to unlock all keys and buttons. Attaching the Presser Foot with the Included Adapter Some presser feet require using the included adapter and small screw, for example, the free motion echo quilting foot "E" and so on. IMPORTANT • Use presser feet made for this machine. Replacing the Presser Foot a Press (Needle position button) to raise the needle. b Touch to lock all keys and buttons. * If the message [OK to automatically lower the presser foot?] appears on the LCD screen, touch to continue. c Raise the presser foot lever. Attaching the Included Adapter and Small Screw a Follow the page 45. steps in "Replacing the Presser Foot" on b Loosen the the presser screw of the foot holder. presser foot holder to remove 1 Presser foot holder screw 2 Presser foot holder d Press the black button on remove the presser foot. the presser foot holder and 1 Black button a 2 Presser foot holder ab c Remove the screw of the the presser foot shaft. presser foot completely from b e Place the new presser foot under the holder, aligning the foot pin with the notch in the holder. Lower the presser foot lever so that the presser foot pin snaps into the notch in the holder. 1 Notch 2 Pin a b 45