Brother International Innov-is XJ2 Operation Manual - Page 195
than the Utility Stitch or Character/Decorative Stitch.
View all Brother International Innov-is XJ2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 195 highlights
ERROR MESSAGES Error messages Cause/solution The bobbin thread is almost empty. 17 This message is displayed when the bobbin thread is running out. Although a few stitches can be sewn when the "Start/Stop" button is pressed, replace with a wound bobbin immediately. When embroidering, touch , touch , remove the embroidery frame, and then replace the bobbin with one wound with plenty of embroidery bobbin thread. If [Upper and Bobbin Thread Sensor] in the general settings screen of the machine setting mode is set to [OFF], this message does not appear. 18 The bobbin winder safety device has activated. Is the thread tangled? This message is displayed when the bobbin is being wound, and the motor locks because the thread is tangled, etc. The safety device was activated since the main 19 shaft motor was heated. Is the thread tangled? This message is displayed when the temperature of the motor increases, activating the safety device. Wait until the temperature decreases. If the error persists, contact your nearest authorized Brother dealer. 20 The safety device was activated since the main shaft motor seized. Is the thread tangled? This message is displayed when the motor locks due to tangled thread or for other reasons related to thread delivery. The safety device was activated since the needle 21 position sensor malfunctioned. This message is displayed when an error in the needle position sensor is detected, activating the safety device. Turn the machine off, then on again. If the message continues to appear, the machine may be damaged. Contact your nearest authorized Brother dealer. Turn off the machine before attaching or removing This message is displayed when you try to sew with a stitch other than a the needle plate. middle needle position stitch while the straight stitch needle plate is 22 installed. This message is displayed when the needle plate is removed with the machine on or when the machine is turned on and embroidery mode is selected. 23 This file cannot be used. This message appears if the file format is incompatible with this machine. Check the list of compatible file formats. (page 194) This file exceeds the data capacity and cannot be 24 used. Use a suitable size file. This message is displayed when the file size exceeds the data capacity of the machine. Confirm the file size and format. (page 194) This key cannot be used at this time. 25 This message is displayed when you touch [Sewing Guide] in the screen other than the Utility Stitch, or touch [Pattern Explanation] in the screen other than the Utility Stitch or Character/Decorative Stitch. 26 This USB media cannot be used. This message is displayed when you try to use incompatible media. For a list of compatible USB media, visit https://s.brother/cpeae/. Turn off the power and replace the needle plate. 27 • This message is displayed when the machine is set to embroidery mode or utility decorative stitch mode from the home page screen while the straight stitch needle plate or no needle plate is installed. • This message is displayed when the straight stitch needle plate is installed while a stitch pattern that cannot be used with that needle plate is selected. 28 USB media error This message is displayed when an error occurs with the USB media. For a list of compatible USB media, visit https://s.brother/cpeae/. When the speed controller is set to control the 29 zigzag stitch width, the "Start/Stop" button does not operate. This message is displayed when the speed control lever is set to control the zigzag stitch width, and the "Start/ Stop" button is pressed. Set [Width Control] to [OFF] in the settings screen to use the "Start/Stop" button (page 20), or use the foot controller to operate the machine (page 75). APPENDIX 7 193