Brother International Innov-is XJ2 Operation Manual - Page 39
Choose a spool cap that best fits the size
View all Brother International Innov-is XJ2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 39 highlights
a Turn the main power to ON. b Press (Presser foot lifter button) to raise the presser foot. The upper thread shutter opens so the machine can be threaded. UPPER THREADING f While holding the thread with both hands, pass the thread through grooves of the thread guide plate. 1 a GETTING READY a 1 Upper thread shutter 1 Thread guide plate g While holding the thread in your right thread through the thread guide in the hand, pass direction the indicated. c Press (Needle position button) to raise the needle. IMPORTANT • Be sure to raise the needle before using the automatic needle threader. Otherwise, the needle may not thread correctly and the needle threader may be damaged. d Remove the spool cap onto the spool pin. and place the spool of thread Slide the spool onto the spool pin so that the thread unwinds to the front from the bottom. h Guide the groove, as thread shown down, in the up, then down illustration. through the a b c d 1 Spool pin 2 Spool cap 3 Spool of thread 4 Spool felt e Slide the spool cap onto the spool pin to the right, with the rounded side on as far as the left. possible Memo • Look in the upper groove area to check if the thread catches on the thread take-up lever visible inside the upper groove area. CAUTION • Choose a spool cap that best fits the size of spool being used. For more information, refer to "Note" on page 31. i Pass the (marked thread through the needle bar thread "6") by holding the thread with both guide hands and guiding it as shown in the illustration. b • If the spool or the spool cap is not positioned correctly, the thread may become tangled around the spool pin, possibly causing the needle to break, resulting in injuries. a 1 Needle bar thread guide 2 Tab 37