Brother International Innov-is XJ2 Operation Manual - Page 33

WINDING/INSTALLING THE BOBBIN d Slide the spool cap onto the spool pin to the right, with the rounded side on as far as the left. possible IMPORTANT • If the spool or the spool cap is not installed correctly, the thread may become tangled around the spool pin, and the machine may be damaged. • Three spool cap sizes are available, allowing you to choose a spool cap that best fits the size of spool being used. If the spool cap is too small for the spool being used, the thread may catch on the slit in the spool or the machine may be damaged. When using mini king thread spool, use the thread spool insert. For details on thread spool insert (mini king thread spool), refer to "Note" on page 31. Note • When using the spool as shown below, use the thread spool insert (mini king thread spool). Make sure that the thread spool insert is firmly inserted. After installing it, pull out some thread, and check that the thread unwinds without getting caught. 1 Thread spool insert (mini king thread spool) 2 Hole diameter 8.0 mm to 10.5 mm (approx. 5/16 inch to 13/32 inch) 3 Spool (crosswound thread) • When using thread that winds off quickly, such as transparent nylon thread or metallic thread, place the spool net over the spool before placing the spool of thread onto the spool pin. If the spool net is too long, fold it to fit the size of the spool. 1 GETTING READY 1 Spool net 2 Thread spool 3 Spool pin 4 Spool cap * When threading the spool with the spool net on, make sure that 5-6cm (approx. 2 - 2-1/2 inches) of thread is pulled out. * It may be necessary to adjust the thread tension when using the spool net. e With your right hand, hold spool. With your left hand, the thread near hold the end of the the thread thread, and use both hands to pass the thread through the thread guide. a 1 Thread guide 31