Brother International Innov-is XJ2 Operation Manual - Page 36
Important, Caution
View all Brother International Innov-is XJ2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 36 highlights
WINDING/INSTALLING THE BOBBIN Using the Spool Stand (Included with Some Models) To wind thread on the bobbin while the spool stand is installed, pass the thread from the spool through the thread guide on the telescopic thread guide, and then wind the bobbin according to steps e through j of "Using the Supplemental Spool Pin"on page 31 to page 33. Setting the Bobbin CAUTION • Use a bobbin that has been correctly wound with thread, otherwise the thread tension may be incorrect and the needle may break, causing injuries. IMPORTANT • When winding thread on the bobbin, do not cross the bobbin winding thread with the upper thread in the thread guides. • Before inserting or changing the bobbin, be sure to touch in the LCD to lock all keys and buttons. Otherwise injuries may occur if the "Start/Stop" button or any other button is pressed and the machine starts sewing. a Touch presser foot. to lock all keys and buttons and raise the * If the message [OK to automatically lower the presser foot?] appears on the LCD screen, touch to continue. b Slide the bobbin cover latch to the right. a b 1 Bobbin cover 2 Latch The bobbin cover opens. c Remove the bobbin cover. d Hold the bobbin with your right hand of the thread with your left hand. and hold the end e Set the bobbin in the unwinds to the left. bobbin case so that the thread 34