Canon MX700 MX700 series Quick Start Guide - Page 87

4 Prepare the replacement tank. (1) Remove the new ink tank from its packaging. (2) Pull the orange tape (B) in the direction of the arrow to peel off the protective film. (3) Remove the film (C) completely. Important Make sure that the protective film does not remain on the air hole (D). If the air hole is blocked with (C) the remaining film, ink may leak out or may not eject properly. (B) (D) (4) Remove the orange protective cap from the bottom of the ink tank. Discard the cap once it is removed. Carefully hold the protective cap (E) when removing it to prevent the ink from staining your fingers. Important z Do not touch the electrical contacts (F) on the ink tank. Doing so can cause the machine to malfunction or become unable to print. z Be sure to remove the clear film from the ink tank in the exact order shown above, as failure to follow this step may cause the ink to leak and stain your clothes and hands. z Do not squeeze the side of ink tanks as this may cause the ink to leak out and stain your clothes and hands. z Do not reattach the protective cap once you have removed it. Discard it according to the local laws and regulations regarding disposal of consumables. z Do not touch the open ink port once the protective cap is removed, as this may prevent the ink from being ejected properly. z Be careful not to stain your clothes and hands with ink on the removed protective cap. (E) (F) 5 Install the ink tank. (1) Insert the front end of the ink tank into the Print Head. (G) Make sure the position of the tank matches the label (G). (1) Routine Maintenance 83