Cisco SPA2102-SF Administration Guide - Page 146

ATA Voice Field Reference Regional page B CWT Frequency Frequency script of the call waiting tone. All distinctive CWTs are based on this tone. The default is 440@-10. Synchronized Ring If this is set to Yes, when a device calls the Linksys ATA, both lines ring at the same time (similar to a regular PSTN line). After one line answers, the other stops ringing. This field is only found in the PAP2T. No is the default. Voice tab > Regional page > Control Timer Values (sec) section Hook Flash Timer Min Hook Flash Timer Max Callee On Hook Delay Reorder Delay Call Back Expires Call Back Retry Intvl Minimum on-hook time before off-hook qualifies as hookflash. Less than this the on-hook event is ignored. Range: 0.1-0.4 seconds. The default is 0.1. Maximum on-hook time before off-hook qualifies as hookflash. More than this the on-hook event is treated as onhook (no hook-flash event). Range: 0.4-1.6 seconds. The default is 0.9. Phone must be on-hook for at this time in sec before the ATA device will tear down the current inbound call. It does not apply to outbound calls. Range: 0-255 seconds. The default is 0. Delay after far end hangs up before reorder tone is played. 0 = plays immediately, inf = never plays. Range: 0-255 seconds. The default is 5. Expiration time in seconds of a call back activation. Range: 0-65535 seconds. The default is 1800. Call back retry interval in seconds. Range: 0-255 seconds. The default is 30. Cisco Small Business ATA Administration Guide 146