Cisco SPA2102-SF Administration Guide - Page 211
VoIP Caller Authentication Method, Line 1 Fallback DP
View all Cisco SPA2102-SF manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 211 highlights
ATA Voice Field Reference PSTN Line page (SPA3102) B Line 1 VoIP Caller DP Index of the dial plan in the dial plan pool to be used when the VoIP Caller is calling from Line 1 of the same SPA3102 unit during normal operation (in other words, not due to fallback to PSTN service when Line 1 VoIP service is down). Choose from {none, 1, 2, 3, 4, 5, 6, 7, 8} Authentication is skipped for Line 1 VoIP caller. Default VoIP Caller DP The default is 1. Index of the dial plan in the dial plan pool to be used when the VoIP Caller is not authenticated. Choose from {none, 1, 2, 3, 4, 5, 6, 7, 8}. Line 1 Fallback DP The default is 1. Index of the dial plan in the dial plan pool to be used when the VoIP Caller is calling from Line 1 of the same SPA3102 unit due to fallback to PSTN service when Line 1 VoIP service is down. Choose from {none, 1, 2, 3, 4, 5, 6, 7, 8}. VoIP Caller ID Pattern The default is 1. A comma-separated list of caller number templates such that callers with numbers not matching any of these templates are rejected for PSTN gateway service, regardless of the setting of the authentication method. The comparison is applied before the access list is applied. If this parameter is blank (not specified), all callers are considered for PSTN gateway service. For example: 1408*, 1512???1234. NOTE: '?' matches any single digit; '*' matches any number of digits. VoIP Access List The default is blank. A comma separated list of IP address templates, such that callers with source IP address matching any of the templates will be accepted for PSTN gateway service without further authentication. For example: 192.168.*.*, 66.43.12.1??. The default is blank. VoIP Caller 1/2/3/4/ One of 8 PIN numbers that can be specified to control 5/6/7/8 PIN access to the PSTN gateway by a VoIP Caller, when the VoIP Caller Authentication Method parameter is set to PIN. The default is blank. Cisco Small Business ATA Administration Guide 211