Cisco SPA2102-SF Administration Guide - Page 179

ATA Voice Field Reference Line page B Fax Tone Detect Mode FAX Tone Detect Mode Symmetric RTP If you want the Gateway to detect the fax tone whether the Gateway is a caller or callee, then select caller or callee. If you want the Gateway to detect the fax tone only if the Gateway is the caller, then select caller only. If you want the Gateway to detect the fax tone only if the Gateway is the callee, then select callee only. This parameter has three possible values: • caller or callee - SPA will detect FAX tone whether it is callee or caller • caller only - SPA will detect FAX tone only if it is the caller • callee only - SPA will detect FAX tone only if it is the callee The default is caller or callee. (SPA3102) Enable symmetric RTP operation. If enabled, the SPA3102 sends RTP packets to the source address and port of the last received valid inbound RTP packet. If disabled (or before the first RTP packet arrives), the SPA3102 sends RTP to the destination as indicated in the inbound SDP. The default is yes. Gateway Accounts section (SPA3102) Gateway1/2/3/4 The first of 4 gateways that can be specified to be used in the to facilitate call routing specification (that overrides the given proxy information). This gateway is represented by gw1 in the . For example, the rule 1408xxxxxxx can be added to the dial plan such that when the user dials 1408+7digits, the call will be routed to Gateway 1. Without the syntax, all calls are routed to the given proxy by default (except IP dialing). The default is blank. Cisco Small Business ATA Administration Guide 179