Cisco SPA2102-SF Administration Guide - Page 223
Supplementary Service Settings Call Waiting Caller ID Generation on or off.
View all Cisco SPA2102-SF manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 223 highlights
ATA Voice Field Reference User page B Voice tab > User page > Supplementary Service Settings section The ATA device provides native support of a large set of enhanced or supplementary services. All of these services are optional. The parameters listed in the following table are used to enable or disable a specific supplementary service. A supplementary service should be disabled if a) the user has not subscribed for it, or b) the Service Provider intends to support similar service using other means than relying on the ATA device. CW Setting Call Waiting on/off for all calls. Block CID Setting The default is yes. Block Caller ID on/off for all calls. The default is no. Block ANC Setting Block Anonymous Calls on or off. DND Setting The default is no. DND on or off. CID Setting The default is no. Caller ID Generation on or off. CWCID Setting The default is yes. Call Waiting Caller ID Generation on or off. Dist Ring Setting The default is yes. Distinctive Ring on or off. The default is yes. Secure Call Setting If yes, all outbound calls are secure calls by default. Message Waiting The default is no. This value is updated when there is voice mail notification received by the ATA device. The user can also manually modify it to clear or set the flag. Setting this value to yes can activate stutter tone and VMWI signal. This parameter is stored in long term memory and will survive after reboot or power cycle. The default is no. Cisco Small Business ATA Administration Guide 223