Fluke 125 Fluke 125 Users Manual - Page 25
Displaying an Unknown Signal with, Connect-and-View™ Auto Set
View all Fluke 125 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
2 Scope/Meter Mode Displaying an Unknown Signal with Connect-and-View™ (Auto Set) Displaying an Unknown Signal with Connect-and-View™ (Auto Set) The Connect-and-View™ function enables hands-off operation to display complex unknown signals. This function optimizes the position, range, time base, and triggering and assures a stable display on nearly all waveforms. If the signal changes, the setup will track these changes. To enable the Connect-and-View™ function, do the following: • Connect the red test lead from red input A to the unknown signal to be measured . Press to select the AUTO (automatic) or the MANUAL mode (toggle function). In the next example, the screen displays "1.411" in large numbers and "+1.000" in smaller numbers. A scope trace gives a graphical representation of the waveform. - The trace identifier (A) is visible at the left side of the waveform area. The zero icon ( ) identifies the ground level of the waveform. Figure 2-2. Scope Screen After an Auto Set 2-3