HP 2700n Service Manual - Page 58
Automatic configuration, Link speed and link duplex settings, Manual, Network Config., TCP/IP config
View all HP 2700n manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 58 highlights
4. Use the < or the > button to select Manual, and then press OK. 5. Press the > button to increase the value for the first section of the IP address. Press the < button to decrease the value. When the value is correct, press OK to accept the value and move the cursor to the next field. 6. If the address is correct, use the < or the > button to select Yes, and then press OK. Repeat step 5 for the subnet mask and default gateway settings. -orIf the IP address is incorrect, use the < or the > button to select No, and then press OK. Repeat step 5 to establish the correct IP address, and then repeat step 5 for the subnet mask and default gateway settings. Automatic configuration 1. On the control panel menu, press OK. 2. Use the < or the > button to select Network Config., and then press OK. 3. Use the < or the > button to select TCP/IP config, and then press OK. 4. Use the < or the > button to select Automatic, and then press OK. It might take several minutes before the automatic IP address is ready for use. NOTE If you want to disable or enable specific automatic IP modes (such as BOOTP, DHCP, or AutoIP), these settings can be changed by using the embedded Web server or the HP ToolboxFX only. Link speed and link duplex settings NOTE Incorrect changes to the link speed and link duplex settings might prevent the printer from communicating with other network devices. For most situations, use the Automatic mode. Making changes causes the printer to restart. Make changes only while the printer is idle. 1. On the control panel menu, press OK. 2. Use the < or the > button to select Network Config., and then press OK. 3. Use the < or the > button to select Link Speed, and then press OK. 4. Use the < or the > button to select one of the following settings. ● 10T Full ● 10T Half ● 100TX Full ● 100TX Half NOTE The printer setting must be the same as the setting for the network device to which you are connecting (a network hub, switch, gateway, router, or computer). 5. Press OK. The printer restarts. 40 Chapter 2 Installation and configuration ENWW