HP Color LaserJet 4730 HP Color LaserJet 4730mfp - Software Technical Referenc - Page 336
Remote firmware update by using the LPR command, Remote firmware update through HP Web Jetadmin, READY
View all HP Color LaserJet 4730 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 336 highlights
Engineering Details NOTE The product automatically turns off and then on again to activate the update; this can happen more than once. At the end of the update process, the READY message appears on the control panel. Do not turn off the product or interfere with the update until you see this message. 8. Print a configuration page and verify that the firmware revision number matches the revision of the current update. Remote firmware update by using the LPR command NOTE This remote firmware update method is for use in Windows NT 4.0, Windows 2000, Windows XP, and Windows Server 2003. Complete the following steps to update the firmware by using the LPR command. 1. From a command window, type lpr -P -S -o l -OR- lpr -S -Pbinps , where can be either the TCP/IP address or the hostname of the product, and where is the filename of the .RFU file. NOTE The parameter (-o l) consists of a lowercase "O", not a zero, and a lowercase "L", not the numeral 1. This parameter sets the transport protocol to binary mode. 2. Press Enter on the keyboard. The messages described in the section Printer messages during the firmware update appear on the control panel. 3. The download process begins and the firmware is updated on the product. This can take several minutes. Let the process finish without further interaction with the product or the computer. The messages described in the section Printer messages during the firmware update appear on the control panel. NOTE The product automatically turns off and then on again to activate the update; this can happen more than once. At the end of the update process, the READY message appears on the control panel. Do not turn off the product or interfere with the update until you see this message. 4. Print a configuration page and verify that the firmware revision number matches the revision of the current update. 5. Type exit at the command prompt to close the command window. Remote firmware update through HP Web Jetadmin This procedure requires that you install HP Web Jetadmin V7.8 or later on your computer. Complete the following steps to update a single product through HP Web Jetadmin after downloading the .RFU file from the HP Web site. 1. Start HP Web Jetadmin. 2. Type the TCP/IP address or IP host name of the product in the Quick Device Find field, and then click Go. The product Status window opens. 3. Open the Device Management folder in the drop-down list in the Navigation panel. Navigate to the Device Lists folder. 314 Chapter 7 Engineering Details ENWW