HP Rp2430 rp24xx A180 User Manual - Page 75

A-Class System Service A-Class Server Trouble Shooting INIT C4CC INIT C4CD INIT 3002 TEST 30BC INIT 30BC INIT C300 TEST 1030 q Service Menu: Enter command > • OSTAT values of TEST and INIT are common during selftest. • OSTAT values of RUN and SHUT are common when the HP-UX operating system is running. • OSTAT values FLT, OFF, and WARN are used to indicate when the server firmware has failed a test or detected a problem that does not keep selftest from finishing. If a fault prevents the server from completing selftest, the OSTAT FLT is used and the Chassis Code displays the test number that failed. If the server stops responding while performing a test, the OSTAT value will be INIT or TEST and the chassis code represents the test that was running when the server failed. Refer to the table below to determine which tests were active when the system either faulted or stopped responding during selftest, and the corrective action to take in response to the problem. Major Code Category 1xxx Description CPU/TLB Tests 2xxx SLC Tests 3xxx PDH Tests 4xxx Late Selftest 5xxx 6xxx 7xxx Bus Transactions Unused Memory Tests 8xxx I/O Device Codes Corrective Action Refer to Replacing an A-Class Server Exchange Base Unit (EBU) Refer to Second Level Cache Memory Module Fault. Refer to Replacing an A-Class Server Exchange Base Unit (EBU) Refer to Replacing an A-Class Server Exchange Base Unit (EBU) Refer to I/O Subsystem or I/O Board Fault NA Refer to Second Level Cache/RAM Memory Module Faults Refer to I/O Subsystem or I/O Board Fault Chapter 3 75