HP Surestore Disk Array FC60 HP SureStore E Disk Array FC60 - (English) Advanc - Page 155
Installing the Disk Array FC60, Connecting the Fibre Channel Cables on, - surestore e disk array factory rack
View all HP Surestore Disk Array FC60 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 155 highlights
Installing the Disk Array FC60 Note The A5277AZ factory assembled disk array is fully configured and requires only connection to the host. Proceed to "Connecting the Fibre Channel Cables" on page 196 to complete the installation. Do not remove any of the factory installed disk enclosures before powering on the disk array, or the disk array will not function properly. If the factory default Fibre Channel address settings (4 and 5) will not work, the settings can be changed as described in "Fibre Channel Host ID Address Setting" on page 179 Installation of the Disk Array FC60 consists of installing the controller enclosure and up to six disk enclosures. Before performing this installation you should have determined the configuration for the array (as described in chapter 2, Array Planning and Topology). You should also review this section prior to performing the installation. The Disk Array FC60 is supported in the System/E racks and in the HP legacy (original) cabinets. Note The HP SureStore E Disk Array FC60 has been tested for proper operation in supported Hewlett-Packard cabinets. If the disk array is installed in an untested rack configuration, care must be taken to ensure that all necessary environmental requirements are met. This includes power, airflow, temperature, and humidity. Failure to meet the required operating specifications may result in product failure. Installation Installing the Disk Array FC60 155