HP Surestore Disk Array FC60 HP SureStore E Disk Array FC60 - (English) Advanc - Page 227
Step 4. Add the New Disk Enclosures, Step 4: Install the Disk Enclosure on,
View all HP Surestore Disk Array FC60 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 227 highlights
Installation CAUTION Do not proceed to the next step if any LUN is not in an optimal state and you intend to move any of the disks which comprise the LUN. Contact HP Support if the LUNs cannot be made OPTIMAL before the moving disk drives. 3. If you intend to move any global hot spares, remove them from the hot spare group as follows: a. Verify that the hot spare disk to be moved is not in use. b. Remove the disk from the hot spare group. 4. Unmount any file systems associated with the disk array. When the file systems are no longer mounted, continue with the next step. Step 4. Add the New Disk Enclosures CAUTION Use proper Electrostatic Discharge (ESD) procedures during the expansion procedure. ESD discharges can easily damage the HP FC60 Array and drive components. Wearing an ESD wrist strap grounded to the component chassis is sufficient for most environments. 1. Power down the disk array components in the following order: a. Switch off power to the controller enclosure. Make sure that both power supplies have been turned off before proceeding. b. Switch off power to each disk enclosure. 2. Remove the Fiber Channel cables connected to the controller enclosure. 3. Disconnect all SCSI cabling from the controller enclosure and the disk enclosures. 4. Install the new disk enclosures in the rack. See "Step 4: Install the Disk Enclosure" on page 162. Adding Disk Enclosures to Increase Capacity 227