HP Surestore Disk Array FC60 HP SureStore E Disk Array FC60 - (English) Advanc - Page 217
Step 3. Reformat Disk Array Media, Step 4. Set Both Controllers to Active State
View all HP Surestore Disk Array FC60 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 217 highlights
Installation Step 3. Reformat Disk Array Media CAUTION This step will destroy all data on the disk array and remove any LUN structure that has been created. If there is data on the disk array, make sure it is backed up before performing this step. If a LUN structure has been created on the disk array either at the factory (A5277AZ) or by a reseller, do not perform steps 3, 4, and 5. Go to step 6 to continue configuration of the disk array. The disk media should be reformatted to its factory default configuration. This operation will destroy any data on the disk array. To initialize the disk media, type: amutil -syswipe Note As the syswipe operation executes, watch the activity LEDs on the disk modules. Each LED should illuminate briefly, starting with the first disk on the first channel, and continiung in a orderly sequence through all the disks. If the LED on any disk remains on noticeably longer than the others, it may indicate that the syswipe operation has encountered a problem. In this case, retry the syswipe operation. Do not continue wth the next step until the syswipe has completed successfully. Step 4. Set Both Controllers to Active State The preceding step sets controller B to the passive states. To reset both controllers to the active state, type: ammgr -c AA Configuring the Disk Array 217