HP Surestore Disk Array FC60 HP SureStore E Disk Array FC60 - (English) Advanc - Page 169
What if LUN 0 is on disks in the enclosure
View all HP Surestore Disk Array FC60 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 169 highlights
Note What if LUN 0 is on disks in the enclosure? If any of the disks in the enclosure are part of LUN 0, you will not be able to unbind the LUN before moving the disks. Instead, you must replace LUN 0 and exclude any of the disks in the enclosures from LUN 0. 4. Power down the disk array, both the array controller enclosure and the disk enclosures. 5. Remove the disk enclosures from the rack. To remove the enclosures, reverse the steps listed in "Installing the Disk Enclosures" on page 160. 6. Install the disk enclosures in the new rack following the instructions in "Installing the Disk Enclosures" on page 160. Make sure the disk enclosure is configured properly for the new disk array. 7. Bind a LUN with the new disks using the management tool of your choice: - To use SAM, see "Binding a LUN" on page 267 - To use Array Manager 60, see "Binding a LUN" on page 289 - To use STM, see "Binding a LUN" on page 314 Note After binding a LUN, you must execute the insf -e command to install special device files on the LUN. This makes the LUN usable by the operating system. Installation Installing the Disk Enclosures 169