HP Surestore Disk Array FC60 HP SureStore E Disk Array FC60 - (English) Advanc - Page 223

Installation Solving Common Installation Problems Problem. When performing an ioscan, the host sees the disk array controllers but none of the disks or LUNs in the disk array. Solution. This is typically caused by powering on the disk array controller enclosure before powering on the disk enclosure(s). Turn off power to all disk array components, power on the disk enclosures and wait for the disks to spin up, then power on the controller enclosure. Problem. When installing a factory-assembled disk array, Array Manager 60 does not see the array. The amdsp -R command does not detect the array, although an ioscan displays the disk array LUNs. Solution. This can result if any of the disk array enclosures are not powered on, or they have been disconnected or removed from the cabinet. Factory-assembled disk arrays have an entire LUN structure created on them. If any of the disk enclosures are missing when the disk array is powered on, the LUNs will appear but they will all have a size of zero bytes. Make sure all disk enclosures are present and powered on before the controller enclosure is powered on. Problem. The ioscan results shows extra LUNs on the disk array. There are several LUN 0 entries for the disk array that I did not bind. Solution. The volume set addressing used by the disk array creates virtual SCSI busses to support addressing up to 32 LUNs. These LUNs do not really exist on the disk array, but are displayed in the ioscan output. For more information, see "Volume Set Addressing" on page 209. Problem. The Array Manager 60 commands are not working. When I attempt to execute a command I get a message indicating that AM60Srvr is not running. Solution. If the AM60Srvr daemon has stopped, no Array Manager 60 commands can execute. AM60Srvr can be restarted using the following command: /opt/hparray/bin/AM60Srvr Solving Common Installation Problems 223