HP Surestore Disk Array FC60 HP SureStore E Disk Array FC60 - (English) Advanc - Page 398
Controller Fan Module, Installing the Front Cover, Removing the Controller Fan Module
View all HP Surestore Disk Array FC60 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 398 highlights
Installing the Front Cover 1. Slide the top edge of the cover up under the lip of the chassis. 2. Push the cover up as far as it will go, then push the bottom in until the pins snap into the mounting holes. Controller Fan Module ! Hot Swappable Component! CAUTION Do not operate the controller enclosure without adequate ventilation and cooling to the controller modules. Operating without proper cooling to the controller modules may damage them. You must shut down the controller enclosure to avoid overheating if you anticipate needing more than 15 minutes to replace the fan module. Removing the Controller Fan Module: 1. Remove the controller enclosure front cover. See "Front Cover Removal/Replacement" on page 397. 2. Loosen the screw on the fan module. See Figure 100. 3. Slide the controller fan module out of the enclosure. 398 Controller Enclosure Modules