HP Surestore Disk Array FC60 HP SureStore E Disk Array FC60 - (English) Advanc - Page 389
Moving Disks from One Disk Array to Another on Mark Slot
View all HP Surestore Disk Array FC60 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 389 highlights
Removal and Replacement Note If the disk module you are installing has been removed from another Disk Array FC60, you should ensure that the module has a status of Unassigned. This is done by unbinding the LUN the disk module was a part of in the original disk array. See "Moving Disks from One Disk Array to Another" on page 255. 1. Remove the replacement disk from its ESD bag, being careful to grasp the disk by its handle (A in Figure 96). 2. Pull the cam latch (B) away from the disk module. 3. Mark the slot number that the disk is being installed into on the Slot Location Map on the top of the disk module. See Figure 95. This facilitates reinstalling the disk module in the correct slot. Mark Slot Figure 95 Disk Slot Identification Label Note Use both hands to hold the disk - one on the handle and the other on the carrier frame. 4. Slide the disk module into the slot with capacity label up (C in Figure 96). Disk Enclosure Modules 389