Panasonic AJ-HPD2500 Operating Instructions - Page 128

External Remote Control Remote Operation of External Devices Use the RS-422A interface to send commands to an external device to control it. The following functions permit remote control. • PLAY, STOP, SEARCH, FF, REW • Counter and status LED indication Setup Procedure Indications during control of external devices In external control mode, the PLAYER lamp goes on and the unit provides the following indications. • The LED goes on to indicate external device status. • Indicates the external device counter • The unit is forcibly set to EE to enable reception of audio and video from the external device • Counter, status and P mark indications for the external device are superimposed on the screen. 1 1 Press the PLAYER button. This allows the unit to perform remote control of external devices. Remote operation procedure The control buttons listed below enable remote control of an external device. STOP PLAY SEARCH REW FF Dial COUNTER RESET Sends the STOP command. Sends the PLAY command. Sends the JOG, VAR or SHTL command. Sends the REW command. Sends the FF command. Sends the JOG, VAR or SHTL command. Sends the switch COUNTER command (CTL/TC only). Sends the 0 reset command in CTL mode. ◆ NOTE: • When performing remote control of external devices, set setup menu No.25 (SYSTEM FREQ) to 59.94, 50, 23.98, 24, 29.97 or 25. • Complete any settings required for controlling a remotely connected device before switching. 128 Connections: External Remote Control