Panasonic AJ-HPD2500 Operating Instructions - Page 207

Display No Character code Description Deck operation Displayed for 3 seconds when a dropout due to reduced hard disk performance occurs Operation 75 HDD INTERMITTENT during hard disk playback for monitoring purposes. continues Use a faster hard disk. 23.98Hz 24Hz 59-23Hz 60-24Hz 60-25Hz only Operation Appears during playback when the time code has been recorded in drop frame mode. continues The video output is distorted and audio output is muted at the drop point of the time code. 93 INVALID TC MODE Check the playback clip. Playing back a 24p frame-rate clip requires that the time code be recorded in non-drop frame mode. Appears when the time code in an HD SDI input is in the drop frame mode during EE or recording. Normal recording will not be possible under these conditions. Check signal input to the unit. Set the input time code to non-drop frame mode. 29.97Hz 59-23Hz 60-24Hz 25Hz 60-25Hz only Operation INVALID EMBEDDED Displayed while synchronizing recorded video frames to the time code of a signal input continues 95 TC to the HD SDI connector when that time code is not advancing at 1× normal speed. (When "SLTC" is selected in setup menu No. 032 (REC REF) or 29.97, 59-23, 60-24, 25 or 60-25 is selected in setup menu No. 25 (SYSTEM FREQ).) 23.98Hz 24Hz 59-23Hz 60-24Hz 60-25Hz only Operation Appears during playback when frame rate data in user bit cannot be detected or when continues the playback time code is not continuous. The video output is distorted and audio output 96 INVALID TC is muted in sections where the time code is not continuous. Check the playback clip. SEQUENCE Appears during EE or recording when frame rate data cannot be detected in the user bit data in an HD SDI input or when the input time code is not continuous. Normal recording will not be possible under these conditions. Check signal input to the unit. Input signals with a matching time code and pull-down sequence. 29.97Hz 59-23Hz 60-24Hz 60-25Hz only Recording is Appears when active frame data cannot be detected in the user bits in the HD SDI input disabled *3 97 NO ACTIVE FRAME during EE or recording. Normal recording will not be possible under these conditions. Operation Check signal input to the unit. The input signal must contain the active frame data from a continues during variable frame-rate camera. (Appears when 29.97, 59-23, 60-24 or 60-25 is set in setup recording menu No. 25 (SYSTEM FREQ) and setup menu No 040 (VFR REC) is set to ON.) 60-25Hz only Operation INVALID FRAME Appears when active frame data detected from the user bit in the HD SDI input during EE continues 98 RATE and recording exceeds 50p. Normal recording is not possible under these conditions. When SYSTEM FREQ is set to 60-25, set the frame rate on a variable frame-rate camera to 50p or less. Appears when SYSTEM FREQ is set to 60-25 and VFR REC is set to ON. ◆ NOTE: *3: An attempt to start recording causes the button to temporarily light. It goes out a few seconds later and no recording is made. For Long and Trouble-Free Operation For Long and Trouble-Free Operation: Error Messages 207