Panasonic AJ-HPD2500 Operating Instructions - Page 36

4 REM(G) 7 REM RX(X)REMOTE CONTROL PROTOCOL RECEIVE 8 REM COMMANDREMOTE CONTROL PROTOCOL TRANSMIT 14 REM RX(Y)REMOTE CONTROL PROTOCOL RECEIVE 15 REM TX(Y)REMOTE CONTROL PROTOCOL TRANSMIT ◆ NOTE: • The ENCODER REMOTE connector supports digital signals only. • Use shielded cable for making connection to ENCODER REMOTE connector. 11.RS-232C connector Use this connector to control this unit from a PC or other device. Pin No. 1 2 3 4 5 6 7 8 9 Signal - TXD RXD DSR SG DTR CTS RTS - ◆ NOTE: • Use double shielded cable for making connection to RS232C connector. 12.REMOTE connector This unit can be connected to an external controller to enable remote operation of the unit or connect and control an external device. RS-422A REMOTE(9P) Pin No. 1 2 3 4 5 6 7 8 9 Signal FRAME GROUND TRANSMIT A RECEIVE B RECEIVE COMMON - TRANSMIT COMMON TRANSMIT B RECEIVE A FRAME GROUND   ◆ NOTE: • Use shielded cable for making connection to REMOTE connector. 13.ANALOG AUDIO connectors Inputs and outputs analog audio signals. CH1/CH2 IN connector: CH1/CH2 OUT connector: MON L/R connector: Analog audio input connectors. A switch permits switching the input impedance of CH1 and CH2. Analog audio output connectors. Outputs signal selected in setup menu No.750 (A CH1/2 SEL). Analog audio output connectors. During playback, these connectors output the audio signals (CH1, CH2, CH3, CH4, CH5, CH6, CH7 and CH8) that are selected with the AUDIO MON SEL buttons. 14.SIGNAL GND connector Connect this connector to the signal ground connector of connected devices to lower noise. This is not a safety ground connector. 15.eSATA connector Enables connection of a hard disk drive with an eSATA connector using the unit as host device. ➝Refer to "Using This Unit With a Hard Disk" (page 118). 16.USB 2.0 HOST connector (Type A) Connect P2 store and USB 2.0 compliant hard disk drives for use in the USB host mode. ➝Refer to "Using USB or eSATA Connectors" (page 116). 17.USB 2.0 DEVICE connector (Type B) Connect personal computers and other devices for use in the USB device mode. ➝Refer to "Using USB or eSATA Connectors" (page 116). ◆ NOTE: • Use double shielded cable for making connections to USB 2.0 connectors. 36 Introduction: Control Reference Guide