Panasonic AJ-HPD2500 Operating Instructions - Page 179
INTERFACE, Setup: Item Settings
View all Panasonic AJ-HPD2500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 179 highlights
Setup Item FR SUPER No. DISP. 160 REPEAT PLAY 165 CLIPSEL MODE 170 AVCHD REC Setting FR SUPER No. DISP. 0000 OFF 0001 ON 0000 0001 TOP THUMB 0000 0001 OFF ON Settings and brief function description Determines whether or not to engage repeat play during playback. 0: Does not engage repeat play. Stops playback at the end of the last clip. 1: Engages repeat play. Continues playback from the beginning when reaching the end of the last clip. NOTE: • Repeat play is not available when the PLAY LIST button is on and during TEXT MEMO playback. • If the P2 card is removed during repeat play, playback is suspended when playback reaches the clip that is no longer exists. • Even if you insert a P2 card during repeat play, additional clips are not played back until you once stop repeat play and resume it. 59.94Hz 50Hz only Selects position of clip displayed by clip select. 0: Uses the first frame of the clip to select clips. 1: Uses clip thumbnail position to select clips. 59.94Hz 50Hz only Selects whether to make AVCHD recording to an SD card either in AVCHD mode or simultaneous with recording to a P2 card. 0: No AVCHD recording 1: Makes an AVCHD recording to an SD card either in AVCHD mode or simultaneous with recording to a P2 card. NOTE: • Displayed only when an AJ-YCX250G AVCHD codec board (optional) is installed. • AVCHD recording is not available when 480i or 576i is set in setup menu No. 020 (SYS FORMAT). Select up-conversion recording to record 480i and 576i input as AVCHD. • Use the setup menu No.774 (AVCHD A CH) to select channels to record. • The start and end of recording may not match the clip recorded on the P2 card. • AVCHD recording is not available when setup menu No. 041 (LOOP REC) is set to ON. INTERFACE This menu specifies the ID data that will be returned to the controller. • XX indicates factory default settings. Item FR SUPER No. DISP. 202 ID SEL 213 EXTEND CMD Setting FR SUPER No. DISP. Settings and brief function description 0000 0001 0002 OTHER Specifies the ID data that will be returned to the controller. DVCPRO 0: OTHER ORIG 1: DVCPRO 2: ORIG NOTE: • Select [OTHER] for ID data for a VTR other than a DVCPRO. • Select [ORIG] only when specific Panasonic controllers (such as AJ-A850, separately sold accessory) are connected. 0000 0001 OFF ON Determines whether or not REMOTE connector commands should be extended to the clip select function and the LAN and USB switching function. 0: Not extended 1: Extended Setup: Item Settings 179